epframes set=0084_0099280101_PNS01804IME.FIT eventset=r04.dat gtiset=g04.dat epframes set='OAL(EPN,IMAGING,2,4)' eventset=r04.dat gtiset=g04.dat epframes set='ODF(EPN,IMAGING,18,4,S)' eventset=r04.dat gtiset=g04.datThis processes CCD 4 of the second IMAGING mode exposure (i.e. PNS018). Diagnostic output images can be created with the additional setting
epframes ... witheventmap=Y eventmapset=m04.datand you can adjust the energy bands with parameters
epframes ... witheventmap=Y eventmapset=m04.dat \ nomipthresholdhigh=... nomipthresholdlow=... \ softthresholdhigh=... softthresholdlow=...If you suspect that your source is not at the nominal position but offset then you may enter for TIMING and BURST modes to get the event times (and later CTI correction in task epevents) correctly:
epframes ... withsrccoords=Y srcra=... srcdec=...If you are interested in the setup of the instrument it is suggested to enable the output of additional messages (if SAS_VERBOSITY = 4 or higher), see also Sect.7.2:
epframes ... showpah=Y showpmh=YIf you have old PMS (odffixed) data you may wish to set
epframes ... odfok=N hkok=Nwhich eliminates a couple of warnings related to missing information in the files that are included and expected in correct (ODS) ODF datasets (this setting should not be used in the GO phase).